Surface Protection Points

When utilizing adhesive surface protection products on a job site there may be always a small risk of adhesive transfer. Improper set up, high temperatures, high traffic, and surpassing the beneficial ‘remove by’ date can all end in problems with carpet masks and films. Following are just a few suggestions to keep away from any adhesive transfer.

Always comply with the manufacturer’s suggestions when using carpet films. Carpet film utilization ratings range from 30 to 60 days. Leaving the film on carpets past the really useful usage ranking invalidates all manufacturers’ warranty.

Use films made in the USA for the perfect warranty protection and highest quality.

Carpet films use either water based or solvent primarily based adhesives. Water primarily based adhesives are easier to remove if a problem occurs.

Never set up adhesive carpet protection on wet or damp carpet.

By no means set up adhesive carpet protection over glue down carpet for a minimum of 72 hours to allow the glue to «breathe».

If carpet has been put in over a newly poured cement slab that isn’t absolutely cured, keep away from utilizing adhesive carpet protection as it can trap the cement moisture and discolor the carpet.

In cases of extreme heat, shorten the beneficial time of application by 50%.

As stated on the set up directions of every film manufacturer, there isn’t a warranty offered for application on wool carpets.

If the above steps are taken, the chance of any adhesive switch when using a carpet film is negligible. In the cases where steps have NOT been adopted, one of these two points may occur: 1) sticky adhesive residue on carpet, or 2) discoloration of carpet where the plastic was used. It is vital at this step to know the type of adhesive used, water or solvent based.

Water primarily based adhesive film residue simply removes with warm water and may be quickly removed by way of steam cleaning the carpets. Solvent based adhesive residue may additionally be removed via steam cleaning nevertheless it could take more than one cleaning to fully remove the adhesive. Citrus cleaners available at any hardware store can typically aid within the removal of solvent primarily based adhesive residue. If further problems persist, contact your local surface protection provider to debate other potential solutions.

Discoloration of carpet is caused by the trapping of moisture under the film and the following response of the moisture and the chemicals within the plastic film. Sadly this situation can only be remedied by removal of the affected space of carpet. This situation happens most commonly in cases where customers have carpeted over slabs that were not absolutely cured.

In case you loved this information and you wish to receive much more information about temporary carpet protection i implore you to visit our web site.

Добавить комментарий

Scroll Up
error: Content is protected !!
%d такие блоггеры, как: