Surface Protection Points

When utilizing adhesive surface protection products on a job site there may be always a small risk of adhesive transfer. Improper set up, high temperatures, high site visitors, and surpassing the beneficial ‘remove by’ date can all lead to problems with carpet masks and films. Following are a couple of suggestions to avoid any adhesive transfer.

Always follow the producer’s recommendations when utilizing carpet films. Carpet film usage ratings range from 30 to 60 days. Leaving the film on carpets previous the beneficial usage score invalidates all producers’ warranty.

Use films made within the USA for the very best warranty protection and highest quality.

Carpet films use either water primarily based or solvent based adhesives. Water based mostly adhesives are easier to remove if a problem occurs.

Never install adhesive carpet protection on wet or damp carpet.

By no means install adhesive carpet protection over glue down carpet for at least 72 hours to allow the glue to «breathe».

If carpet has been installed over a newly poured cement slab that is not totally cured, avoid using adhesive carpet protection as it can trap the cement moisture and discolor the carpet.

In cases of extreme heat, shorten the beneficial time of application by 50%.

As stated on the set up instructions of each film producer, there isn’t a warranty offered for application on wool carpets.

If the above steps are taken, the prospect of any adhesive transfer when using a carpet film is negligible. Within the cases where steps have NOT been adopted, one in all these two points may occur: 1) sticky adhesive residue on carpet, or 2) discoloration of carpet the place the plastic was used. It will be significant at this step to know the type of adhesive used, water or solvent based.

Water based mostly adhesive film residue easily removes with warm water and could be quickly removed through steam cleaning the carpets. Solvent primarily based adhesive residue may be removed by way of steam cleaning nevertheless it could take more than one cleaning to totally remove the adhesive. Citrus cleaners available at any hardware store can typically aid within the removal of solvent based mostly adhesive residue. If further problems persist, contact your local surface protection supplier to debate different potential solutions.

Discoloration of carpet is caused by the trapping of moisture under the film and the subsequent response of the moisture and the chemical compounds in the plastic film. Unfortunately this situation can only be remedied by removal of the affected area of carpet. This situation happens most commonly in cases where users have carpeted over slabs that weren’t totally cured.

In the event you loved this information and you would want to receive more details concerning corex please visit our page.

Добавить комментарий

Scroll Up
error: Content is protected !!
%d такие блоггеры, как: